Publicité
Step 1
å
Assemble your unit on a carpeted floor or on the empty
carton to avoid scratching your unit or the floor.
å
Using your hammer, gently tap two LEVELERS (46E)
completely into the holes in the LEFT END (B).
å
NOTE: Adjustments to the LEVELERS will be made later in
assembly once your unit is standing upright.
Hardware Usage Guide
HOW TO USE A TWIST-LOCK
1.
Push a TWIST-LOCK® FASTENER
into the large hole in the part.
www.sauder.com/commercial-office/service
Look for this icon. It means a video assembly tip is
available at www.sauder.com/service/tips
Find the numbered video or scan the QR code.
B
FASTENER
®
2.
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
426277
0
46E
Dowel end
Page 5
Publicité
