Publicité
Les langues disponibles
Les langues disponibles
2. To maximize flush cutting capabilities, insert the blade
shaft into the blade clamp with the teeth of the blade
facing up.
3. Turn the saw upside down so you are as close to the work
surface as possible.
Wood cutting
1. Before cutting any type of wood, be sure the work piece
is firmly anchored or clamped to prevent slipping.
2. Place blade and shoe lightly against work to be cut.
3. Switch on saw motor before applying pressure.
Metal cutting
1. In thin gauge sheet metals it is best to clamp wood to the
underside of the sheet. This will ensure a clean cut
without excess vibration or tearing of metal.
2. Avoid forcing cutting blade as this reduces blade life and
causes costly blade breakage.
Pocket cutting
English
1. Measure the surface area to be cut and mark clearly with
a pencil, chalk or scriber.
2. Insert blade in blade clamp and tighten blade clamp
securely.
3. Tip the saw backward until the bottom edge of the shoe is
resting on the work surface.
4. Switch motor on, permitting blade to attain maximum
speed.
5. Grip handle steadily and begin a slow, deliberate upward
swing with the handle of the saw.
6. The blade will begin to feed into material. Always be sure
blade is completely through material before continuing
with pocket cut.
Always hold saw firmly with both hands while cutting.
Whenever possible, the shoe must be held firmly against the
material being cut. This will prevent the saw from jumping
or vibrating and minimize blade breakage..
8
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
9
WARNING
CAUTION
CAUTION
WARNING
EN
Publicité
