Inventum KC222WOS Mode D'emploi page 14

4
using the ceramic heater
Insert the plug in a socket.
SWITCHING THE HEATER ON AND OFF
Turn the position button to one of the four positions and carefully turn the thermostat button towards the maximum
position, until you hear a click sound. The heater switches on and the indicator light burns.
heating - low capacity
heating - high capacity
heating and oscillating - low capacity
heating and oscillating - high capacity
Turn the position button to the off position [
THERMOSTAT BUTTON
The heater has a thermostat to regulate temperature and is therefore able to keep a room at room temperature.
Turn the thermostat button to the maximum position and turn the position button to one of the heating positions to switch
on the heater. The indicator light burns.
Once the required temperature is reached, you slowly turn back the thermostat button towards the minimum position,
until you hear a click sound. The heater switches off. The heater will now switch on and off automatically to maintain the set
room temperature. The indicator light will switch on and off, in correspondence with the thermostat. If you do not want the
heat to keep the room at temperature automatically, you must switch off the heater with the position button and remove
the plug from the socket.
OSCILLATION
This heater is able to oscillate (swivel to the left and right) for a better air displacement. Select a heating position with
oscillation so that the heater starts to oscillate and heat.
SAFEGUARDS
The heater is provided with an overheating protection and an anti-tilting protection.
Overheating protection
When the heater gets too hot due to the ambient temperature or as a result of prolonged use, the heater switches off
automatically. Allow the heater to cool before you switch it on again.
Anti-tilting protection
When the heater falls over accidentally, the protection switches off the entire heater automatically. When the heater is
standing straight again, the heater switches back on.
5
cleaning and maintenance
Before cleaning the heater, switch it off and remove the plug from the socket. Allow the heater to cool down fully before
cleaning or storing it. Regularly clean the heater. At least once per seasonal use.
• Clean the exterior of the appliance with a dry cloth only.
• If necessary, you can clean the inlet and outlet openings by means of a vacuum cleaner (nozzle).
• Do not use aggressive or abrasive cleaning agents for cleaning the appliance.
• Never submerge the heater in water or any other liquid.
• Preferably store the heater in its original packaging on a cool, dry place.
6
breakdowns and solutions
First check the following if your heater is not working.
• Check the fuses in the meter cupboard.
• Check that the plug is properly inserted in the socket and that the socket receives power.
• Check that the thermostat button is in the right position.
• Keep the heater clean. Dust, dirt and/or contamination in the heater are common causes of overheating. Make sure that
such contamination is removed regularly.
• If the heater suddenly stops while heating, it is possible that the overheating protection is activated. Switch off the heater,
remove the plug from the socket and allow the heater to cool down. Switch on the heater according to the instructions,
after it has cooled down.
14
• English
] to switch off the heater. Remove the plug from the socket.