Frigidaire A06823703 Mode D'emploi page 4

4
Important Safety InStructIonS
Important InStructIonS for
unpacKInG and InStaLLatIon
cautIon
for GeneraL VentILatInG uSe
onLy. do not uSe to eXHauSt
HaZardouS or eXpLoSIVe
materIaLS or VaporS.
Important
Read and follow the below instructions
and precautions for unpacking, installing,
and servicing your appliance.
cautIon
to reduce risk of fire and to properly
exhaust air, be sure to duct air outside
- do not vent exhaust air into spaces
within walls, ceilings, attics, crawl
spaces, or garages.
WarnInG
to reduce tHe rISK of fIre, uSe
onLy metaL duct WorK.
Install this hood in accordance with all
requirements specified.
WarnInG
to reduce tHe rISK of fIre,
eLectrIc SHocK, or InJury to
perSonS, oBSerVe tHe foLLoWInG:
a) Installation work and electrical wiring
must be done by qualified person(s) in
accordance with all applicable codes
and standards, including fire-rated
construction.
b) Sufficient air is needed for proper
combustion and exhausting of gases
through the flue (chimney) of fuel
burning equipment to prevent back
drafting. Follow the heating equipment
manufacturer's guideline and safety
standards such as those published by
the National Fire Protection Association
(NFPA), and the American Society
for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and
the local code authorities.
c) When cutting or drilling into wall or
ceiling, do not damage electrical wiring
and other hidden utilities.
d) Ducted fans must always be vented to
the outdoors.
WarnInG
to reduce the risk of fire or electric
Shock, do not use this Hood With
any external Solid State Speed control
device.
WarnInG
to reduce tHe rISK of fIre,
eLectrIc SHocK, or InJury to
perSonS, oBSerVe tHe foLLoWInG:
a) Use this unit only in the manner
intended by the manufacturer. If you have
questions, contact the manufacturer.
b) Before servicing or cleaning unit,
switch power off at service panel and
lock the service disconnecting means
to prevent power from being switched
on accidentally. When the service
disconnecting means cannot be locked,
securely fasten a prominent warning
device, such as a tag, to the service panel.