Publicité
Les langues disponibles
Les langues disponibles
Getting started
1. Remove the appliance from the box.
2. Remove any packaging from the product.
3. Place the packaging inside the box and either store or dispose of safely.
Contents of carton
1. Electric Fireplace
2. Wall fixing bracket
3. Fixing screws and wall plugs
4. Remote control
5. Instruction manual
6. 1 bag of decorative pebbles (If your Fireplace is with "log fuel effect", no pebbles are included)
Helpful advice before fitting
1. Please retain all packaging until you have checked and counted all the parts and the contents of
the fixing pack against the parts list.
2. The fixing pack contains small items which should be kept away from young children
3. We suggest that you open the fixing pack and place all the contents into a container, therefore
reducing the risk of losing any small pieces
1. Do not connect the appliance until properly fixed to the wall and the instructions is read fully
2. The minimum distances must be observed
3. For installation of the appliance, care must be taken not to damage concealed cables
4. Please be careful while drilling the holes.
5. This appliance is designed to be permanently fixed to a wall at a minimum height of 300mm.The
wall bracket must be fitted horizontally and the cable routed to the bottom right of the heater
6. A height of 600mm from bottom of heater to floor is recommended for optimum viewing of fuel
bed. Keep top of heater at least 1 meter away from ceiling or other object for optimum heat
ventilation. (For recommend fixing dimensions, see Fig. 1 of the diagram that corresponds to your
Fireplace model number)
7. For optimum viewing, mark the top four screws fixing positions on wall in accordance with the
recommend fixing dimensions (see Fig.2). Drill holes with a six drill bit.(for EF450/EF451)
For optimum viewing, mark the top five screws fixing positions on wall in accordance with the
recommend fixing dimensions (see Fig.2). Drill holes with a six drill bit.(for EF423/EF430/EF431)
8. Fix the wall bracket using that the plug and screws provided
9. Carefully lift the heater up ensuring that the top rear ledge of heater engages the wall bracket
(see Fig.2 in circle) and is sitting centrally
10. Gently bring the heater level with the wall
11. Mark the bottom holes position (see Fig.3), remove the heater ensuring that the bottom fixing
bracket is rotated up
12. Drill and fit wall plug
13. Refit the heater to the wall fixing bracket and rotate the bottom fixing bracket down again and use
the screw provided to permanently fix the heater in place
14. Unpack the pebbles from the bag and place them along the light unit in the desired position.
(Disregard this instruction if your Fireplace is with "log fuel effect")
15. Place the front panel over the front of the fire aligning the slots in the brackets at each side of the
panel with the lugs on the sides of the fire (see Fig. 4). Again two people will be required for this
operation
GETTING TO KNOW YOUR HEATER
INSTALLATION
Publicité
