Greencut GTC220X Manuel D'utilisation page 67

TILLAGE
1. Set the depth setting lever to the desired working depth.
2. Move the throttle control to "fast - hare".
3. Press the forward gear lever "forward", and both the traction and the tiller blades will automatically start
working.
SAFETY CONTROL DRIVE LEVERS
LEVER FORWARD:
Push the burs and wheels forward.
Pushing down the safety control lever "forward" towards the handlebars moves the teeth and wheels. With the stop
lever, the teeth and wheels make the power tiller make a complete stop.
LEVER BACKWARDS:
Hook the wheels and burs back.
When the reverse gear lever is actuated, the operation of the cultivator is reversed.
ADJUSTMENTS AND TIPS
ATTENTION: Turn off the motor before making adjustments. Use caution when using the reverse
lever.
WHEEL LOCKING PINS
TO LOCK THE WHEELS:
1. Remove the locking pin. Align the hole in the axle with the hole in the wheel rim.
2. Insert locked pins into the holes, pass the double ring through the pin to secure the shaft.
3. Securely lock the axle and wheel together before working.
4. Repeat on the other wheels.
NOTE: Do not operate the power tiller with only one wheel locked.
TO UNLOCK THE WHEELS AND PUT THEM IN THEIR FREE POSITION:
1. Remove the locking pin. Slide the wheel into the machine.
2. Insert the pin only into the shaft.
3. The wheel must rotate freely on the axle.
WHEEL LOCKING AND
UNLOCKING PIN (MECHANICAL
TRACTION/NO MECHANICAL
TRACTION)
67
EN