Publicité
Les langues disponibles
Les langues disponibles
FINAL STEPS
IMPORTANT: reinstall the dismounted or partially removed stock parts (wheel arches,
bumper etc.); check vehicle manufacturer manual for tightening torques.
IMPORTANT: make sure all the nuts and bolts are sufficiently tightened. In case the
exhaust system touches the cowling or other parts, repeat the adjustment of the
exhaust system or contact your authorized dealer.
IMPORTANT: clean all exhaust components before the first start of the engine or the
stains will burn onto the surfaces!
TROUBLESHOOTING
Problem
Exhaust gas is leaking out
of the exhaust system
Valve is not working / moving
Exhaust system rattles /
doesn't fit properly
Errors and omissions excepted!
Possible cause
loosened clamp
connection is not
completely joined
Valve is mechanical stuck
Valve is not working correct
Exhaust System is not mounted correct
12
Solution
tighten all connections to specified torque
loosen the connection and tap it into place,
tighten the connection to specified torque
Remove the actuator and try to move the valve
by hand.
Use spray lubricant (WD-40® or equivalent) to
make the valve working again.
Make sure the actuator is powered correctly.
Make sure the actuator is mounted properly
onto the valve and the valve spins correctly.
loosen all connections again and readjust/
align the whole system once more
Publicité
