LENCO SB-040 Mode D'emploi page 13

3: Turn on the Bluetooth function on your devices and the
device will start to search for the Soundbar.
4: Select "Lenco SB-040" from the list of found devices.
5: If asked, enter the password "0000" and press OK.
6: When successfully paired with your device, the indicator
light will be lit steadily.
Note: The Bluetooth playback is controlled by your
device and the buttons on the remote control.
Note: The operation range for the Bluetooth connection
is 10 meters.
Note: If a mobile phone on which you are playing music
receives a call, the music will be interrupted and not
played. After call end, the devices are connected to each
other again and playback continues.
7: Press and hold the Bluetooth button on the Remote
Control for 3 seconds to disconnect the Bluetooth
pairing.
AUX Source:
1: Ensure that the soundbar is connected to the TV or
other audio device via an AUX cable.
2: Press the AUX button on the Remote control to enter
the mode. You can also short press the source button on
the soundbar to choose the AUX source.
3: The indicator light will lit in green.
Note: The playback is controlled by your device and by
the button on the remote control.
LINE IN Source:
1: Ensure that the soundbar is connected to the TV or
other audio device via an audio cable.
2: Press the LINE IN button on the remote control to enter
the mode. You can also short press the source button on
the soundbar to choose the LINE IN source.
3: The indicator light will lit in orange.
Note: The playback is controlled by your device and by
the buttons on the remote control.
12