Publicité
Les langues disponibles
Les langues disponibles
CHAPTER -6: TROUBLESHOOTING
• Is your freezer on a level surface?
If the edges of freezer cabinet that the door joint contact are warm;
Especially in summer (hot weather), the surfaces that the joint contact may get warmer during the operation of the
compressor, this is normal.
IMPORTANT NOTES:
• The compressor protection thermal fuse will cutout after sudden power breakdowns or after unplugging the
appliance, because the gas in the cooling system is not stabilised. This is quite normal, and the freezer will
restart after 4 or 5 minutes.
• The cooling unit of your freezer is hidden in the rear wall. Therefore, water droplets or ice may occur on the rear
surface of your freezer due to the operation of the compressor in specified intervals. This is normal. There is no
need to perform a defrosting operation unless the ice is excessive.
• If you will not use your freezer for a long time (e.g. in summer holidays) unplug it. Clean your freezer according
to Part 4 and leave the door open to prevent humidity and smell.
• The appliance you have purchased is designed for home type use and can be used only at home and for
the stated purposes. It is not suitable for commercial or common use. If the consumer use the appliance in
a way that does not comply with these features, we emphasise that the producer and the dealer shall not be
responsible for any repair and failure within the guarantee period.
• If the problem persists after you have followed all the instructions above, please consult an authorised service
provider.
EN -10-
Publicité
