Télécharger Imprimer la page

Zibro SRE 139 E Manuel D'utilisation page 49

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
G: The TIMER indicator
light indicates that the
timer function has been
switched on.
higher setting and the key on the left ( hour) to lower the temperature. Press
once to increase the value one step. After approximately 10 seconds the °C mark
and 4-digit will stop blinking and the setting will be locked (Fig. F).
The available temperature settings range from 6°C minimum to 28°C maximum.
When the heater has been unplugged (or after a power failure), the temperature
will reset to the factory setting of 20°C.
F
USING THE TIMER
The timer allows you to switch on the heater automatically at a preset time.
In order to switch on the timer, the correct time must have been set (refer to
Section C) and the heater should be off. Follow the procedure below:
button ¹ and then the TIMER key
1
Press the
The TIMER lamp
Use the adjustment keys
2
Use the key on the left ( hour) to set the hours and the key on the right
( min.) to set the minutes (interval of 5 minutes).
After approximately 10 seconds the 4-digit will show CLOCK again and the
3
TIMER lamp
activated (Fig. G).
The timer will ensure that the room will have been heated to approximately
4
the required temperature at the set time.
When you want to switch off the heater and ignite it again with the timer, all
you have to do is press the TIMER key (refer to Section G).
button ¹ once to clear the timer setting.
Press the
G
SWITCHING OFF THE HEATER
There are two ways to switch off the heater.
button ¹. The information display will show the CLOCK
Press the
1
signal. Within approximately one minute the flame will have extinguished.
Press the TIMER key
2
again with the timer the next time. This not only switches off the heater, but
it also activates the timer function. You can change the required time with
the adjustment keys
and the 4-digit ¸ will start blinking.
to set the time at which the heater must ignite.
will light up, indicating that the timer function has been
, when you want to switch off the heater and ignite it
(refer to Section F).
immediately after that.
4
47

Publicité

loading