Garland 1080 QG Manuel D'instructions page 35

mandatory.
The machine is designed only for outdoor use. Avoid
using the machine in outdoor areas with a high
probability of exhaust fumes.
The machine must be used by only one person at a
time.
Never insert your hands in the entry chute until the
machine has been stopped and the blades have
stopped rotating.
The pieces of wood that might have got stuck
transversally must only be removed when the machine
has been stopped and the blades have stopped
rotating.
In the case that the rotor is blocked by a piece of
wood:
- Disconnect the machine, remove the cover of the
rotor axis and turn the rotor axis a few degrees
with a specific spanner designed for this.
- After this, remove the piece using a stick or
something long.
ATTENTION: DO NOT INTRODUCE YOUR HANDS IN
THE ROTOR
The use of working
gloves, ear protection
and working glasses is
35/160
Never leave the machine unattended or functioning.
Stop the engine and spark plug before replacing the
blades or counter blades.
After an hours work, check the screws and nuts are
still well tightened. If not so, tighten them.
Always use original spare parts, if not you shall lose
your warranty.
The machine should only be repaired by an authorized
after sales dealer.
6.4.2. STARTING THE ENGINE
Before starting engine:
Make sure check the engine oil, fuel tank and SC
System deactivated before starting the engine.
6.4.2.1 SC SYSTEM SAFETY SYSTEM
This machine has an automatic machine stop system
in the event that the user involuntarily inserts a hand
into the hopper. Before starting the machine check
that the SC System handle is ON to start the machine.
6.4.2.2. COLD-STARTING THE ENGINE
A. Place the ON/OFF switch in the "ON" position.
B. Place the fuel tap in the open position.
English