Murray EQ2-700X Mode D'emploi page 14

User manual and warranty card
 Protective equipment should be used. Always wear safety glasses. Wearing protective equipment
such as a dust mask, non-slip shoes, helmet or hearing protectors under the right conditions will
reduce personal injury.
 Before starting the equipment, remove all objects and keys. Leaving the key in the rotating
working part of the machine can cause personal injury.
 Do not lean too far. You should always stand firm and balance. This will allow better control in
unpredictable situations.
 Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and gloves away
from moving parts. Loose clothes, jewelry or long hair can be caught in moving parts.
 When working, hold the tool by the additional handles if the tool is equipped with them. Losing
control of the tool carries the risk of injury.
 Do not use the device if you have trouble turning it off. Any device that cannot be turned off is
dangerous and must be repaired.
Caution! Despite the use of a safe structure by design, the use of protective measures and
additional protective measures, there is always a residual risk of injury during work.
USE AND CARE FOR EQUIPMENT

Do not overload the tool. Use a tool with the power appropriate for the work. Properly selected
equipment will enable better and safer work under the load for which it was designed.

Store the unused equipment out of the reach of children. Do not allow people not familiar with
the tool or this manual to use the equipment. Internal combustion tools and equipment are
dangerous in the hands of untrained users.

Internal combustion tools must be maintained. Check alignment or jamming of moving parts,
cracked parts and all other factors that may affect the operation of the device. If damage is
found, the equipment must be repaired before use. Many accidents are caused by improper
repair and / or maintenance of the equipment.

Before using the device, replace all defective, worn and damaged parts. Replace with new
warning signs on the device if they become illegible or damaged.

Warning decals and spare parts can be ordered from Murray service and authorized dealers.

An internal combustion tool, equipment, working tools etc. should be used in accordance with
these instructions, taking into account the conditions and the type of work to be performed.
Using the device in a manner not intended for it may be dangerous.
OPERATION AND EXPLOITATION OF TOOLS EQUIPPED WITH A BATTERY

Before inserting batteries into the tool, make sure that its on / off switch is in the "off" position.
Inserting the batteries into the device when the on / off switch is in the "on" position can cause
serious injury.

Use only the charger recommended by the manufacturer. Using a charger to charge other types
of batteries may cause a fire.

Never use batteries other than those recommended by the manufacturer. Use of other batteries
may result in serious injury or fire.

When the device is not in use, remove the battery. The battery should be kept away from metal
objects such as paper clips, coins, nails, screws, etc., which may short-circuit the battery
terminals. Shorting the battery terminals together may cause burns or a fire.
14
English