XFL3/4/5-LED
INSTALLATION INSTRUCTIONS
Adjustable optics:
1.
Using the provided tool [9], turn the slot on the top of the fixture to adjust
the beam distribution from Extra Wide (7x6), to Wide (6x6), and/ or to
Medium Wide (5x5).
CCT, Lumen Select, Photocontrol:
1.
Remove the screw cap (shown on the left in the image) to reveal CCT and
Wattage switches [13]. Fixture is set to highest wattage and 4000K standard.
2.
Remove the screw cap shown on the right in the image to reveal the
Photocontrol sensor and switch [12]. Photocontrol is set to ON as standard.
WIRING
•
Check that the line voltage is correct.
•
Connect fixture GROUND (green) wire to power supply GROUND (green) wire.
•
Connect fixture WHITE wire to power supply NEUTRAL wire.
•
Connect fixture BLACK wire to power supply LINE wire
•
The fixture includes 0-10V dimming functionality, connect PINK and VIOLET
wires to a 0-10V dimming controller (optional).
RAB Design Lighting inc.
[7]
[10]
[9]
[11]
Loosen to
adjust angle
[12]
]
August– 2023
[8]
[10]
[13]
PINK
Page 2 of 5