RAB Design DWL-LED Instructions D'installation

INSTALLATION INSTRUCTIONS
IMPORTANT: READ CAREFULLY BEFORE INSTALLING FIXTURE. SAVE THESE INSTRUCTIONS.
WARNING: Before installation disconnect power by turning off the circuit breaker.
Turning the power off by using the light switch is not sufficient to prevent electrical shock.
SAFETY: This fixture must be wired in accordance with the Canadian Electrical Code, and
applicable local codes and ordinances.
A qualified electrician should perform all wiring.
Proper grounding is required to ensure personal safety.
Fixture is for outdoor use and should not be used in areas of limited ventilation or high
ambient temperature.
Fixture should be wall mounted, at least 12" away from any combustible materials
Fixture should not be recessed
REMOVE FRONT HOUSING (Fig.1)
Loosen the two screws "A" on the housing. Remove front housing.
REMOVE REFLECTOR (Fig.2)
Loosen the two screws "B" to allow reflector to slide
downward and remove reflector.
MOUNTING ON JUNCTION BOX (Fig.3)
Knock out appropriate holes around outlet hole in rear housing.
Fasten the rear housing to the junction box using the screws supplied
with the junction box.
ELECTRICAL CONNECTIONS
Use insulated wire connectors to:
 connect fixture ground (green) wire to power supply ground (green) wire.
 connect fixture white wire to power supply white wire.
 connect fixture black wire to power supply black wire.
Push connected wires through fixture outlet hole into the junction box.
REATTACH REFLECTOR AND FRONT HOUSING
Reattach reflector and front housing by reversing the procedure used
to remove the parts.
CONNECTION USING BOTTOM CONDUIT HOLE (Optional):
With front housing and reflector off, remove plug in the bottom of the rear housing.
Pull service wires through bottom of conduit hole and make electrical connections
in appropriate conduit connector.
Reattach reflector and front housing by reversing the procedures used to remove the parts.
DWL-LED
DWL-LED