Publicité
Les langues disponibles
Les langues disponibles
Translation of the original instructions
«MANUAL» MODE (FIG IV)
To set your device, proceed as follow:
- Choose the welding voltage using the 6 positions switch
Example: position 1 for 0,6 mm metal sheets and position 6 for 4 mm metal sheets.
- Adjust the wire speed with the potentiometer(2).
Advice:
The wire speed adjustment is often determinated « with the noise »: the arc must be stable and have a low
crackling. If the speed is too low, the arc is not continuous. If the speed is too high, the arc crackles and the wire
pushes back the torch.
«SYNERGIC» MODE (FIG IV)
This function will set the wire speed automatically.
For this:
Position the wire speed potentiometer (2) in the middle of the« Optimal synergic » zone.
-Select:
-The wire type (5b)
-The wire diameter (5a) The power mode (6 positions switch), to select the right position in accordance with the thic-
kness of the part to weld, please refer to the table (fig V)
From this combination, they determines the optimal wire speed and the device is ready to weld. It is also possible
to adjust the wire speed if necessary by adjusting potentiometer (2) + or – manually. A memory of the last welding
configuration is done (wire diameter, wire type, mode).
GAS choice (only for steel welding) :
In synergic mode, it's determines the welding settings in accordance with the gas used. By default, in steel welding
the machine is set in « Argon + CO2 ».
To change the gas and set the machine in C02 mode or come back in Argon + CO2 mode, process as explained:
1-Press « Type » for 5 seconds until the keyboard switches off the release.
2-Within 5 seconds, choose the required setting with the key « choose mode ».
-Normal (2T) => Argon + CO2 (default setting)
-Delay => CO2 100%
3-The confirmation is done either by the « Type » key, or by waiting for 5 seconds.
4-Once confirmed, the machine reverts to the normal functioning mode but the modification is registered even when
the machines is switched off.
SPOT MODE (FIG IV)
This function allows spot welding. To adjust the length of each spot, use the potentiometer (3).
DELAY MODE (FIG IV)
Allows intermittent welding, the delay can be adjusted through the potentiometer (3).
This function allows welding very thin steel metal sheet, limiting the risk of piercing and distortion.
ADVICE AND THERMAL PROTECTION
- Respect the basic rules of welding.
- Leave the air holes of the device open to allow air circulation.
- Leave the device plugged after welding to allow its cooling.
- Thermal protection: The light (fig IV-6) turns on and the cooling duration is a couple of minute according to the area
temperature.
SYMPTOMS, REASONS, SOLUTIONS
SYMPTOMS
The welding wire speed is not constant.
MIG 240 208/240 V
CAUSES
Cracklings blocking up the opening.
The wire skids in the rollers.
REMEDES
Clean out the contact batch or change it
and replace the anti-adherence product.
Control the roller pressure or replace it.
Wire diameter non-consistent with roller
Covering wire guide in the torch not
consistent with wire.
EN
11
Publicité
