Publicité
Les langues disponibles
Les langues disponibles
English
(2) As shown in Fig. 8, slide the blade in the direction
indicated by the arrow to disassemble the blade.
2. Cutter blade assembly
CAUTION:
Prior to assembly, thoroughly wipe off all swarf
accumulated on the cutter blade.
(1) Insert a turned portion of set plate (A) attached to
the blade into a groove on the flat portion of the
cutter block. (Fig. 9, 10)
Set the blade so that both sides of the blade
protrude from the width of the cutter block by about
3/64" (1 mm) (Fig. 11)
Flat portion of the
cutter block
Set plate (A)
Groove
Fig. 10 (Correct installation)
10
Set plate (B)
Fig. 8
Set plate (A)
Fig. 9
Blade
3/64" (1 mm)
Blade
(2) Place the blade holder on the completed assembly,
as shown in Fig. 12, and fasten it with the three bolts.
Ensure that the bolts are securely tightened.
Bolt
(3) Turn the cutter block over, and set the other side in
the same manner.
3. Adjustment of cutter blade height:
CAUTION:
As the set gauge has been accurately factory
adjusted, never attempt to loosen it.
(1) Loosen the 2 screws holding on the blade and set
plate (A). (Fig. 13)
(2) Press the turned surface of set plate (A) to the wall
surface b while adjusting the blade edge to the wall
surface a of the set gauge. Then, tighten them with
the 2 screws. (Fig. 14, 15)
3/64" (1 mm)
Cutter block
Fig.11
Blade holder
Fig. 12
Machine screw
Fig. 13
Publicité
