NaceCare Solutions HD 14 Mode D'emploi page 9

Activate the cursor N to release the ven-
tilation grille and at the same time slide
out the grille (in the direction of the arrow)
to free it. The prefilter is located in the air
outlet area under the Hepa filter. Replace
or clean the prefilter by washing it with
water, then dry it and put it carefully back
in place. Refit the HEPA filter and venti-
lation grid, sliding it in until you hear the
cursor click into place.
STARTING THE CARPET BEATER
To work, press the release pedal down
and lower the vacuum cleaner at the same
time. The carpet beater attachment will start
up. Avoid frequent use of the carpet beater
attachment on special rugs or carpets that
could become damaged over time.
ENGLISH
CARPET BEATER CONTROL
The carpet beater control device constantly
regulates the operation of the beater:
Green light: the carpet beater is working
correctly.
Red light: the carpet beater is locked or
it has been subjected to excessive stress.
Lift the base with the adjustment device
P, then move the appliance to the upright
position for a few seconds and resume
working. If the red light persists, switch
off the appliance, unplug it and check the
causes of blockage.
Red/Green light: the roller is not touching
the floor. Adjust the height of the base
using the dial P. It is possible that the roller
is worn or the transmission belt is broken.
Replace the roller or transmission belt.
9