Philips X-tremeVision LED Mode D'emploi page 7

• Connect the control box to the two connectors
on the lamp.
• Place the wiring harness into the chamber of
the lamp. Be careful to avoid the air inlet of
the fan.
• Put on the air-tight cover for the lamp.
• Check if the lamp works normally and if the
light pattern is okay. If the light pattern is too
low or too high, adjust the horizontal
adjustment knob for the lamp until the
position is correct.
• Place the removed halogen lamp into the white
empty box.
6 Installation steps for reflector lamps
• Swing to open the air-tight cover for the
original headlight.
Figure-2
• Loosen the spring latch and remove the halogen
lamp from the existing headlight assembly.
• Insert the plastic ties into the pre-secured
holes on the control box.
• Insert the ties into the wiring harness for
the lamp.
7