koban KLD7-BAT Mode D'emploi page 14

KLD7-BAT
Infrared LED Sensor Lamp
CONNECTION-WIRE DIAGRAM:
SENSOR INFORMATION:
Height of installation: 1.8-2.5m
TEST:
--Turn the TIME knob anti-clockwise
on the minimum. Turn the LUX knob
clockwise on the maximum (sun).
--Switch on the power; the lamp will
have no signal at the beginning. After
Warm-up 30sec, the lamp can start work .
If it receives the induction signal, the lamp will turn on. While there is no another
induction signal any more, the lamp should stop working within 10sec±3sec.
14
Figure1
Note: Connect the electronic
wire from battery with LED
panel first, then continue to
connect the lamp with AC power
Figure2
Detection Distance: Max.9m
www.grupotemper.com
Figure 3