koban KLD7-BAT Mode D'emploi page 13

Welcome to use our KLD7-BAT Infrared LED Sensor Lamp with emergency!
The product is an energy-saving automatic sensor lamp, adopting integrated circuit
and precise detecting components. It gathers automatism, convenience, safety,
saving-energy and practical functions. Its performance is stable. It can identify day
and night. The lamp can turn on when one enters detection field and can turn off
automatically when one leaves detection field.
SPECIFICATION:
Power Sourcing: 110 -240V/AC
Power Frequency: 50/60Hz
Ambient Light: <3-2000LUX (adjustable)
Time Delay: Min. 10sec±3sec
Max.5min±1min
LED rated power: 15W (1100LM)
Detection Motion Speed: 0.6-1.5m/s
Color Temperature:4000K
Emergency Load: 1.2W (DC) (65LM)
Continuous illumination time: 5hours(when the battery power supply)
FUNCTION:
--Can identify day and night: The consumer can adjust working state in different ambient
light. It can work in the daytime and at night when it is adjusted on the "sun" position
(max). It can work in the ambient light less than 3LUX when it is adjusted on the "moon"
position (min). As for the adjustment pattern, please refer to the testing pattern.
--Time-Delay is added continually: When it receives the second induction signals within
the first induction, it will restart to time from the moment.
--Adjustable Time Delay: the length of time delay could be set according to the customers'
requirement, the minimum time of this item is 10sec±3sec, and the maximum is
5min±1min.
Good sensitivity
INSTALLATION:
--Switch off the power.
--Unload the plastic cover to open it. (refer to figure1,2)
--Pass the wire through the hole in the bottom and connect the power wire into
connection-wire column according to the connection-wire diagram. Install the sensor
lamp in the position where you need with inflated screws. (refer to figure3)
--Switch on the power and test it.
www.grupotemper.com
Infrared LED Sensor Lamp
Detection Range: 160°/360°
Detection Distance: wall: max.9m(<24℃)
Working Temperature: -20~+40℃
Working Humidity: <93%RH
Installing Height: wall 1.8-2.5m
ceiling: 2.2-4m
LED Lifespan:50.000h
KLD7-BAT
ceiling: max.6m(<24℃)
Poor sensitivity
13