Installing The Camera; Wiring - Clarion CC510 Mode D'emploi Et Manuel D'installation

Installing the camera

Option 1: Peel of double-sided tape backing from
bracket (A) and place camera in suitable location.
Adjust camera angle by using adjustment screw.
Option 2: Installing the camera with CAU001
please use bracket B.
*CAU001 not included.
CAUTION
• When adjusting the camera
position, do not allow the camera
cable to be excessively stretched or
loose.
• Periodically check the tightness of
the installation screws and retighten
if necessary.

6. WIRING

1. Lead the camera cable into the vehicle and align it along the vehicle weather stripping.
Use cable holders as necessary to fix the wires in place to prevent from being pinched
in hinges or dampers.
2. Fix the cable with adequate looseness in this area to prevent it from being stretched or
pinched in the hinge when the rear gate is opened and closed.
6
CC510
Option 1:
Protective
paper
Mounting
bracket A
Option 2:
for CAU001 only
Bracket
from CAU001
Mounting
bracket B
To Video Input
Connect to +12V
Switched Accessory
(Red Wire)
Connect to
Chassis Ground
(Black Wire)