Acuva ArrowMAX 1.2 Mode D'emploi page 12

ENGLISH
APPENDIX A: FAUCET INSTALLATION INSTRUCTIONS
1. Drill a 3/4" hole into the counter-top where the Smart Faucet will be inserted.
2. Thread the faucet cable into the 3/4" hole and insert the faucet stem into the hole.
3. Thread the faucet power cord through the plastic spacer under the counter to ensure that the
cord is not pinched against the counter when the faucet is fastened into place, making sure that
the spacer's O-ring seal is facing up to seal against the counter.
4. Add the plastic threaded fastener to the faucet stem and tighten the fastener against the spacer
to secure the faucet into place. Make sure that the faucet is positioned properly as required before
tightening the fastener.
5. To connect the ¼" water line to the faucet stem, slip the hex nut onto the tube, followed by the
plastic ferrule and plastic tube support. Press the tube end and ferrule to the bottom of the faucet
stem and tighten the hex nut by hand, then tighten the nut one quarter turn with a wrench.
1/4" Water Line
12
Hex Nut
Tube
Support
Ferrule
Faucet Cable
Spacer
Fastener
ArrowMAX 1.2 User's ManUal
Smart Faucet