Nolangroup N-Com ESS III Mode D'emploi page 20

EN
4.1. Auto On / Off function
If the helmet does not move for more than 60 seconds, the system goes into "deep sleep" mode. The
system is completely turned on as soon as movement is detected.
If the system is in "deep sleep" mode for more than 3 days, it turns off completely. To switch it back
on, you need to press the Function key.
4.2. Emergency Stop Signal
The ESS system is equipped with a LED system to assist emergency braking. In case of sudden
braking, the LEDs on the ESS flash for a few seconds.
N.B.: ESS system is unrelated to the braking system of the bike, as it analyses the acceleration
sustained by the helmet independently.
4.3. Rear light
The rear light makes it possible to activate the LEDs of the ESS system, keeping them on during the
entire ride.
If the emergency brake light is activated during braking, all LEDs will start flashing.
4.4. Flashing light
The flashing light allows you to be more visible in case of fog or limited visibility. If selected, the LEDs
of the ESS system will flash intermittently.
If the emergency brake light is activated during braking, all LEDs will start flashing.
8