Zipper Maschinen ZI-MD500HS Mode D'emploi page 34

15.3.2 Check oil level
 Place machine on a level ground
 Remove oil cap
 Wipe oil from the dipstick
 Replace the dipstick without tightening the oil cap!
 Pull out the dipstick again.
 Check the oil level. Oil level must be between min and max
 Fill in oil if low level
15.3.3 Fill hydraulic oil
In the hydraulic oil tank on the top right is approximately 3,5 liters of hydraulic oil -eg
HL 46- or similar filled.
15.3.4 Refuel
Use only unleaded fuel with min. 95 octane or higher
Never use 2-stroke mixture of diesel! DAMAGE OF ENGINE!
 Refuelling only outdoors!
 Before removing the filler cap, turn the
engine off and let it cool machine
 Clean the fuel filler cap area
 Remove the filler cap carefully
 Fill in fuel
 Fuel tank capacity: 6 l. Fill tank only up
to 1,5 cm below the rim of the filler
neck, so that the fuel has place for
expansion.
 Replace and tighten the filler cap
 Wipe any fuel residues and wait until it
evaporates
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MD500HS
All manuals and user guides at all-guides.com
W A R N I N G
OPERATION
34