HomeMatic IP HmIP-ESI-IEC Notice D'installation Et D'emploi page 18

General system information
5 General system information
This device is a part of the Homematic IP
Smart Home system and communicates
via the Homematic IP wireless protocol.
All devices of the Homematic IP system
can be configured comfortably and
individually with a smart phone via
the Homematic IP app. Alternatively,
you have the option of operating
Homematic IP devices via the CCU3
or in conjunction with many partner
solutions. The available functions
provided by the system in combination
with other components are described
in the Homematic IP User Guide. All
current technical documents and
updates are provided at
www.homematic-ip.com.
6 Start-up
Only put the cover (B) on once
you have completed the mount-
ing and installation work.
6.1 Pairing
Please read this entire section
before starting the pairing proce-
dure.
First set up your Homematic IP
access point using the
Homematic IP app so that you can
use other Homematic IP devices
in the system. For further
information, please refer to the
operating manual of the access
point.
So that the device to be integrated into
your system and to communicate with
other Homematic IP devices, it must
first be paired on the Homematic IP
Access Point.
For pairing, proceed as follows:
• Open the Homematic IP app on
your smart phone.
• Select the menu item "Add device".
• Remove the cover (B) to open the
battery compartment (F).
• When mounted, the cover (B) can
be removed by pressing in the up-
per and lower sides and pulling the
cover (B) forward.
1
1
• When not mounted, the cover cap
(B) can be removed by pressing in
the upper and lower sides with one
hand. At the same time, take hold
of the rib of the electronics unit (G)
on the rear side of the HmIP-ESI
with your other hand and pull it out
of the cover.
2
1
2
1
18