Fender Passport Serie Mode D'emploi page 5

All manuals and user guides at all-guides.com
If you have purchased a wireless system and find you're Passport does not
have the "wireless ready" feature, please contact your Authorized Fender
Pro Audio dealer or our Customer Service department for information and
availability of a "wireless retrofit kit." This kit will need to be installed by an
Authorized Fender Pro Audio Service Center.
Safety Precautions
Warning: To avoid the risk of shock or fire, do not expose this unit to moisture.
Do not attempt to disassemble or alter any circuitry. There are no user-
servicable parts inside. Refer all servicing to an Authorized Fender Pro Audio
qualified service personnel.
Installation
Custom Docking Receiver
Unplug and Disconnect the power cable from the Passport System!
Identify the Docking Receiver module and familiarize yourself with the unit,
noting the two mounting screws and multi-pin connector.
Place your Passport tower face down on a level and stable surface. Open the
storage compartment door and identify the docking connector on the rear
wall of the storage compartment.
Locate the two small screws attaching the protective cover over the docking
connector. Loosen the screws just enough to allow the cover to be removed
from the connector. Do not remove the screws completely! Gently re-tighten
the two screws.
Holding the Docking Receiver with the logo in an upright position, place the
male, multi-pin connector into engagement with the female connector on
the Passport storage compartment rear wall. When properly aligned, gently
(but firmly) push the unit until it engages fully. Using the two screws on
the sides of the module, attach the module to the Passport. Do not over-
tighten.
Identify the two "blanking plugs" and install these into the channel one, XLR
and 1/4" connectors.
Wireless Components
Receiver
The UHF Docking Receiver Module wireless receiver is built into the "docking"
unit that mounts inside Passport's storage compartment. All power, audio
and antenna connections are built into the docking receiver.