Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
Never cover the heater or obstruct the opening at the base of the heater, this could cause overheating
and consequent risk of fire.
Never move the heater when it is operating, this could cause the bulb breakdown. Please turn the heater
off if you want to move it.
When you turn the heater on for the first time you may notice a slight odor, this is harmless and will stop
after a short amount of time.
Heater Control Panel
The following switches are located at back of door.
1
3a
3b
3c
2
Insert plug into mains socket
Select the desired functions:
· Switch ( 3a ) Switchs ON/OFF electricity supply to the heater and flame effect
Note: This switch must be in the ON position for heating operation.
· Switch ( 3b) Switchs ON/OFF 750W heat output
· Switch ( 3c ) Switchs ON/OFF 1500W output with switch 3b
Note: The flame effect can be operated with or without heat.
· Rotate thermostat control (1) clockwise or anti-clockwise to achieve desired room temperature.
· Increase or decrease the flame effect by rotating the flame adjustment switch (2).
SAFETY Cut-Off
This appliance is fitted with a safety cut-off which will operate if the heater overheats (e.g. Due to blocked
air vents). For safety reasons, the heater will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes. Reconnect
the supply to the mains and switch on the appliance.
MAINTENANCE
Before cleaning or maintenance operation, switch off and unplug the appliance. Ensure it is perfectly
cooled.
To remove the dust, wipe the appliance with a cloth
Never use abrasives or detergents
BULB REPLACEMENT
This product does not use a standard bulb for its flame effect. The appliance uses an electronically
controlled LED system to create the effect, therefor no parts need to be replaced. There are no user-
3
Publicité
