Ledvance RDORKIT7AS030UNVD8SC814BLE Manuel D'installation page 4

Optional Sensor Installation
The LEDVANCE Retrofit Door Kit 7A offers a Plug & Play Motion Sensor that is sold separately.
Figure 7
The luminaires are shipped with a
plate that covers the sensor hole
(Fig. 7). The plate can be removed
either before or after you install
the fixture in the ceiling.
Install the sensor by snapping it
into the slot. Ensure it is securely
fixed (Fig. 10).
Fixture Bluetooth Control
The LEDVANCE LINKTM mobile application can be downloaded from the App Store or GooglePlay. The fixtures can also be controlled
using the optional wireless wall switch. Please refer to the LEDVANCE LINKTM commissioning guide available at www.LEDVANCEUS.com.
4120523
There is a flexible flat cable with a
terminal secured to the back of the
plate (Fig. 8).
The fixture and the sensor are
Figure 10
controlled using the LEDVANCE
TM
LINK
(available in the App Store or
GooglePlay) and/or the optional
wireless wall switch.
One sensor can be configured to
control up to 100 fixtures using the
Group and Linkage function –
refer to the LEDVANCE LINK
commissionig guide.
Figure 8
mobile application
TM
Figure 9
Remove the flat cable that was
secured to the back of the plate
and insert the connector to the
in
back of the optional sensor 65785
(Fig. 9).