Hensel AXM 20 Instructions De Montage page 14

- Classification: Ex equipment cable gland with clamping by the
sealing ring for entry of non-armoured and braided cables.
Liability and warranty
All information is provided on the basis of the accepted technical
status of development and under due consideration of our
revious experience and knowledge.
We do not assume liability for damage resulting from
disregarding these operating instructions or unauthorized
modifications.
Conformity with standards and directives
- EN IEC 60079-0:2018+AC:2020-02
- EN IEC 60079-7:2015+A1:2018
- EN 60079-31:2014
- EN 62444:2013
- Directive 2014/34/EU
- Low voltage directive 2014/35/EU
26
Safety
Symbols in the instruction manual
Important notes are identified by symbols:
WARNING!
There is danger of injury or even death!
WARNING!
Danger of electric current.
Disregard causes danger of injury or even death!
ATTENTION!
Possible damage of equipment.
Safe use
- Read carefully and observe this instruction manual
- Store the instruction manual at the installation location
- Ex equipment cable glands are only approved and only to be used
for the following puposes:
- for entry of fixed installed cables
- in enclosures and equipment with type of protection "ec"
(Increased safety) and "tc" (Protection by enclosure)
27