Télécharger Imprimer la page

LEXIBOOK Star Wars TW100SW Manuel De L'utilisateur page 10

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
1. Fitting the batteries
Your TW100SW works with 3 x LR03/AAA batteries 1.5V
(not included) for each walkie-talkie.
To fit the batteries
1. Unscrew batteries cover located at the back of the unit, and
remove the cover from the battery compartment.
2. Insert the batteries according to the polarity (+/- signs).
3. Replace the cover and tighten up the screw of the battery
compartment cover.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed
from the product before being charged. Rechargeable batteries are only to be charged under
adult supervision. Different types of batteries or new and used batteries are not to be mixed.
Only batteries of the same or equivalent type as recommended are to be used. Batteries are to
be inserted with the correct polarity. Exhausted batteries are to be removed from the product.
The supply terminals are not to be short circuited. Do not throw batteries into a fire. Remove the
batteries if you are not going to use the product for a long period of time.
Notes:
- The walkie-talkie watches consist of two modes: communication and watch.
- When the batteries are installed, the walkie-talkie watches automatically enter
communication mode.
- The Lexibook® Walkie-Talkie Watches are each equipped with an automatic energy
saving function. They switch to energy saving mode (the backlight turns off) when no
incoming signals are received within 5 minutes.
WARNING: Mal-function or loss of memory may be caused by strong frequency
interference or electrostatic discharge. Should any abnormal function occur, remove the
batteries and insert them again.
2. Installing / removing the watch straps
The watch straps of your TW100SW are removable.
This means you can use your TW100SW either as a
walkie-talkie watch by wearing it on the wrist or as a
classic walkie-talkie.Your TW100SW watch is delivered
assembled. If you want to remove the watch straps,
please follow these steps:
1. Unscrew the screw from the battery compartment
located on the back of the device and remove the cover.
2. Remove each strap by sliding it toward the inside of the
battery compartment.
10
3. Wearin
1. Put the
the strap i
2. Adjust t

Publicité

loading