König Health Care HC-SM10 Manuel page 4

All manuals and user guides at all-guides.com
Caution:
1. Please remove batteries if the product is not in use for a long time.
2. Never apply the electrode pads to your skin with the power supply on. Doing so may result in
sudden shock.
3. There are some areas of the body to which the pads cannot be easily affi xed. For this case, use
surgical tape from your local pharmacy to secure the pads.
Treatments:
1. Turn the power on by pressing the power switch. The TAP symbol will appear on the LCD
screen.
2. Select the desired treatment mode by pressing the MODE button.
3. Raise the intensity gradually by twisting the intensity control for both channels A and B. Both
channels can be set separately according to your needs.
4. When you change the treatment mode, the stimulation of the current treatment will stop. Set the
intensity for the new mode by twisting the intensity control again. After treatment, turn off the
power button.
Examples of treatment modes:
1. Tap - It promotes blood circulation by several kinds of stimulation such as high speed, low speed
etc.
2. Modulation - It releases fatigue by several kinds of stimulation such as low speed, high speed and
alternation of these speeds.
3. Kneading - It gradually releases neuralgia or muscular pain by stimulation such as strong and soft
pressures.
In the above 3 modes, the stimulation in A and B channels are constant and it is possible to treat
2 part of the body at the same time.
Standard intensity, time, numbers of uses:
Intensity: The intensity of the stimulation is felt differently by each individual and also will vary with
physical conditions. The strength of the batteries and the conditions of the electrodes also play a
role. Therefore adjust the intensity control button to a position you feel most comfortable.
Caution:
Do not assume that by increasing the intensity of the stimulation that there will be a stronger effect.
This may very well not be the case. However it is possible that excessive stimulation to the skin will
result in irritation or red eruptions.
Time: A standard amount of use per area is 10-15 minutes. A single treatment should not exceed
30 minutes.
Number: A standard number of use per day is 1-2.
There may be some people who feel fatigue. In this case lower the intensity, shorten the time, and
limit the number of uses to once a day.
4