König Health Care HC-SM10 Manuel page 3

All manuals and user guides at all-guides.com
10. Do not use while sleeping.
11. After use, unplug the electrode cord from the main unit and coil it around the electrode holder for
storage.
Body:
Electrode jack
Intensity state
Mode state
LCD display
Speed state
Open/reinforce key
Close/reduce key
Mode key
Intensity/speed key
Correct use:
Installing the battery
1. When replacing the batteries, be sure that the power is off.
2. Open the battery compartment by pushing it gently in the direction of the arrows.
3. Insert the battery and make sure that the (+) and (-) polarities match the diagram indicated at the
back of the unit. Slide the battery cover completely shut.
4. Batt.2 x AAA (3V)
Preparing & setting the electrodes:
1. Correctly connect the electrode cord to the electrode pads.
2. Insert the plug of the electrode cord into the unit's electrode jack.
3. Peel off the fi lm from the electrode pads.
4. Use a damp towel to wipe the area of skin on which you will be affi xing the pads to remove any
oil, cosmetic or dirt.
5. Should the electrode pads be soiled, both their adhesiveness, and the number of times of possible
use will be reduced.
6. Apply the electrode pads to the area of the body you wish to massage. The unit cannot operate
unless both pads from at least one channel are applied.
3