Publicité
Les langues disponibles
Les langues disponibles
Ye
e
f™ gen yao om, gate heen, V A bake
Ce
creole gs
1 | Tighten 90° elbow fitting to valve
Be sure rubber washer is properly seated in fitting. Slide the
¥4" fitting up to the valve and hand tighten to avoid cross-
threading. Hand tighten until the coupling is tight.
Using pliers, check the tightness of the coupling. An additional
Ya to Ye turn may be required to seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can result.
Place paper towel under 90° elbow fitting. Turn on water supply
and check for leaks. If leak occurs, repeat previous step.
If needed, see website for animated representation of this step.
Visit www.maytag.com/watersupply under FAQ tab.
NOTE: Do not use Teflon® tape with compression fittings.
T®TEFLON
is a registered trademark of E.I. Du Pont De Nemours and Company.
18
Black drain hose
connector
Place towel under drain hose to catch any water in drain hose.
Place the small green drain hose clamp onto the small end of the
drain hose. Push the new drain hose into the black drain hose
connector up to the drain hose stop.
Green clamp
Black drain hose
connector
Drain hose
Drain hose stop
Stop
Using pliers, squeeze open the small green drain hose clamp and
slide onto connector between stops.
Black drain hose
connector
After hose is connected, remove towel.
If needed, see website for animated representation of this step.
Visit www.maytag.com/drain under FAQ tab.
Publicité
