Baxall DVS24 Manuel D'installation Et D'utilisation page 8

All manuals and user guides at all-guides.com
The caption should now be displaying the model number and
software version.
Use <1> to move the caption up and <2> to move it down.
Press <4> and the display changes to the software date.
Use <1> to move the caption left and <2> to move it right.
Release <AUTO>.
To display the software version ... follow the instructions for
positioning a caption on the screen (above.)
To RESET your DVS2 to factory defaults ... Remove the power
plug from the back of your DVS2. Press and hold <AUTO> and
<SPOT> re-insert the power plug, wait for 3 seconds then release
<AUTO> and <SPOT>.
Using the DVS2 with Alarms
The AL8 has 8 alarm inputs, its function is to tell the DVS2 which
o f the alarms are active. The DVS2 assumes that
alarm 1 = camera 1, alarm 2 = camera 2 and so on. When only
one alarm is active the DVS2 shows the alarmed-camera on the
main monitor. If two or more alarms are active it can either:
• only display the most recent alarmed camera or,
• introduce the alarmed camera into a special sequence with a 2
second dwell-time.
Then, once the alarms are all cleared it can either:
• hold the last alarmed camera on the main monitor,
• start the normal sequence on the main monitor or,
• return to the settings it had before the first alarm.
A flashing LED indicates that the corresponding alarm is active
or has been active. Press the numbered key to cancel this once the
alarm is cleared.
English Page 7