Publicité
Les langues disponibles
Les langues disponibles
4. Test the operating range.
Place the chime and pushbutton in
their desired locations and press the
pushbutton. If the chime sounds, pro-
ceed to step 5. If the chime does not
sound, refer to the "Troubleshooting"
section for help.
5. install the chime.
Use the hardware (provided) to
mount the chime on a wall. The
chime can be mounted by using the
holes in the back of the case or by
using 2 screws with the keyholes.
Snap the front of the chime case
back on.
close
chime
case from
bottom
6. install pushbutton.
Use the hardware (pro-
vided) to attach the back
plate of the pushbutton
to its mounting surface.
Make sure the long tab is
at the bottom.
If mounting the pushbut-
ton to a metallic or con-
crete surface: Increase
the operating range by
using wood spacers be-
tween the back plate and
the mounting surface.
Snap the pushbutton
case onto the back plate.
keyholes
T OP
BACK
PLATE
LONG TAB
7. check operation.
Depress pushbutton and listen for
chime. If necessary, adjust volume
using the control on the back of
chime. If chime does not function
properly, refer to "Troubleshooting"
section.
-
+
BaTTeRY RePlacemenT
chime
Open chime case. (see step )
Replace batteries with three .5V
alkaline, size "D" (R20) batteries.
Close chime case.
Pushbutton
Open pushbutton case (see step
2). Replace battery with one 2V
alkaline, type A23 (Model CA23),
or MN2 battery. Close pushbutton
case.
addiTiOnal dOOR
chimes
Additional wireless door chimes
can be set to ring separately from
or together with other wireless door
chimes. Set the pushbutton and
chime frequency codes accordingly.
See page 3.
2
chime
Volume
control
1
6
Publicité
