Publicité
Les langues disponibles
Les langues disponibles
page 4
LAMP AIMING
To adjust the lamphead at
1
housing, twist lamphead to the
desired position. (Do not loosen
torque nut inside the housing.)
Rotating lamphead on housing should
be done by swiveling head assembly.
(Do not loosen torque nut inside the
housing.)
Federal Communications Commission (FCC)
Requirements:
This device complies with FCC Title 47, Part 15, Subpart B.
this device does not cause harmful interference.
LAMP AIMING
Exploded View
LIFE SAFETY SOLUTIONS
740-345-9631
.holophane.com
TEL:
WWW
To adjust the lamphead around the
2
Aiming Screw, loosen Aiming
Screw and aim lamphead to desired
position.
Tighten the screw to finish aiming
3
procedure.
(Torque spec: 12 in-lbs)
Aiming
Screw
CAUTION: To aim, do not rotate the
lamphead without loosening the aiming
screw. Failure to do so will lead to
breakage of gasket of the Yoke mount.
© 2020, Acuity Brands Lighting, Inc.
Part # 912-00096-001
Rev. C, 06/2021
All Rights Reserved.
Publicité
