ECS Electronics CR-002-DB-N Instructions De Montage page 5

Remove the battery earth cable. Remove the trunkfloor in the boot.
1.
Remove the treshold in the boot. Remove the side covers at the lefthand sight of the boot.
Remove the cover behind which a 14-pole connector is situated.
Clear the entrance to both rearlightunits.
Remove the coverplate of the fusebox above the pedals.
Drill a 40 mm hole at the leftback of the trunkfloor, at the leftside of the grommet near the wheelbox.
2.
Carefully remove all metal particles and treat the edges with anti-rust.
Lead the end of the 12-pole wiring harness and the two remaining wiring looms with each 4 wires through the 40 mm hole
3.
underneath the vehicle. Fit the grommet in the hole.
Lead the end of the 12-pole wiring harness between the bumper and the body through the grommet to the socket.
(Careful, hot exhaust!)
Fit the wires as indicated:
DIN/ISO 11446
1/L gelb
2 blau
1-8
3/31 weiß
4/R grün
5/58-R braun
STOP
6/54 rot
7/58-L schwarz
8 schwarz/rot
Reverse
-
15 amp.
+
9 braun/weiß
30+
-
15 amp.
+
10 rot
15+
11 weiß
10
12
rot/blau
9 13
weiß
Mount the socket to the towbar.
Lead the remaining wires between the bumper and the body to the rearlights.
4.
The other wires are connected to the original wiring with connectors (see figure 1).
Left rearlight:
5.
Cut the wire on position 2 of the 6-pole connector at a distance of 10 cm.
Connect the grey wire to the wire coming from the connector/lamp direction.
Connect the red/yellow wire to the wire from the vehicle direction.
Cut the wire on position 4 of the 6-pole connector at a distance of 10 cm.
Connect the yellow wire to the wire coming from the connector/lamp direction.
Connect the other yellow wire to the wire coming from the vehicle direction.
Right rearlight:
Cut the wire on position 2 of the 6-pole connector at a distance of 10 cm.
Connect the grey wire to the wire coming from the connector lamp/direction.
Connect the red/yellow wire to the wire from the vehicle direction.
Cut the wire on position 4 of the 6-pole connector at a distance of 10 cm.
Connect the green wire to the wire coming from the vehicle direction.
Connect the other green wire to the wire coming from the connector/lamp direction.
Fasten the wiring harness under the car with the included cable binders.
© ECS 2001
FITTING INSTRUCTIONS ELECTRIC WIRINGKIT TOWBAR WITH 13-P SOCKET UP TO
DIN/ISO NORM 11446
CHRYSLER JEEP GRAND CHEROKEE WJ 1999-
Partno.: CR-002-DB
D F GB
jaune
yellow geel
bleu
blue blauw
blanc
white wit
vert
green groen
marron
brown bruin
rouge
red rood
noir
black zwart
noir/rouge
black/red zwart/rood
marron/blanc
brown/white bruin/wit
rouge
red rood
blanc
white wit
rouge/bleu
red/blue rood/blauw
blanc white wit
CR-002-DB-E
NL
11
200700I
Reverse
8
7
1
9
10
8
9
7
1
6
10
2
2 4
11
5
3
12 13
12
3 13
1
2
A
B
3
fig. 1
6
STOP
4
5
REVISIE 1