Publicité
Les langues disponibles
Les langues disponibles
Automatic defrosting:
ƒ
When the ambient temperature is low (around 10°C), the surface temperature of the fins and
evaporator tubes could be below 0°C while the machine is running in dehumidification mode.
This can lead to freezing of the condensates on the evaporator.
Accumulated frost will obstruct the air flow and hinder the refrigeration cycle. Before this phenomenon
becomes too pronounced, the machine is programmed to automatically trigger a defrosting cycle by
stopping the compressor and the circulation of air.
The symbol
will appear on the control panel screen.
The air will gradually melt the frost, the compressor will restart automatically once the frost is completely
melted.
Nota bene:
For the defrosting function to be effective, it is important not to run the machine at ambient
temperatures below 10°C.
Shutting down the device:
ƒ
Press the On/ Off button.
The compressor will stop, approximately 30 seconds later, the fan will also stop.
Nota bene
There is a minimum time delay before the fan and compressor can be restarted (approximately
30 seconds for the fan and approximately 2 minutes for the compressor).
Locking/ unlocking the key pad:
ƒ
To deactivate the key pad, press the two arrow keys ( and ) simultaneously and hold them down for
three seconds.
The following symbol will appear on screen:
To reactivate the key pad, repeat this operation.
Verifying and setting the operating parameters:
ƒ
This menu is reserved to qualified maintenance professionals.
To enter the parameter setting menu, hold the SET key down for at least 3 seconds. Use the arrow keys
and to scroll through the parameters until the parameter that you wish to verify or modify is displayed
on screen.
While the dehumidifier is running, it is possible to view the parameters but not to modify them.
While the machine is stopped, parameters may be both viewed and modified.
24/28
2017/05 - Indice de révision : D - Code : 33491
Publicité
