Publicité
5. Using the MULTIMETER Mode
You can use the Channel Setup screen (page
Logger MULTIMETER mode sampling is triggered by a calculator operation.
• To use the MULTIMETER mode
1. Connect the calculator and Data Logger, and connect the sensors you want to the
applicable Data Logger channels.
2. From the Advanced Setup menu (page
configure sensor setups for each channel you will be using.
3. After configuring the sensor setups, press w to return to the Advanced Setup menu
ε
-8), and then press 2(MULTI).
(page
• This starts sampling in the Data Logger
MULTIMETER mode and displays a list of sample
values for each channel.
• Displayed sample data is refreshed at 0.5-second
intervals.
• Do not connect sensors to any other channels except
for those you specified in step 2.
• Data sampled in the MULTIMETER mode is not saved in memory.
4. To end MULTIMETER mode sampling, press the w key.
ε
-23
Using the MULTIMETER Mode
ε
-9) to configure a channel so that Data
ε
-8), use the Channel Setup screen (page
ε
-9) to
Publicité
