Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE LIGHT KIT AND GLASS SHADE
Mounting hub
(bottom of motor)
Light wires
Adapter
plate
Fig. 1
WARNING: To avoid possible electrical shock, be sure
electricity is turned off at the main fuse box before
installing light kit.
If you do not plan to install the light kit with your fan at this
time, skip Step 5.
Remove one of the three screws on the mounting hub
1
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 1)
Pass the light wires through the center hole of the adapter
2
plate.
Place the key holes on the adapter plate over the 2 screws
3
previously loosened, turn the adapter plate until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed.
Remove one of the three screws on the adapter plate
4
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 2)
Wire connectors
Screws
Fig. 2
5
6
5
7
8
Adapter plate
Light kit
Glass shade
or optional
metal cover
While holding the LED light kit under your fan, make the
polarized plug connections: (Fig. 2)
- White to white
- Black to black
Tuck connections neatly into adapter plate. Place the key
holes on the light kit over the 2 screws previously loosened,
turn the light kit until it locks in place at the narrow section of
the key holes. Secure by tightening the 2 screws previously
loosened and the one previously removed.
Raise the glass shade or metal cover against the LED light kit
and turn clockwise until snug, DO NOT OVERTIGHTEN.
Restore power and your light kit is ready for operation.
Screws
| hinkley.com |
©2023 Hinkley Lighting, Inc.
13
Publicité
