Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL CONNECTIONS
WARNING: To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE - Control must be installed within 30 feet of fan.
WARNINGS: Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire nuts, except for
the ground wire.
WARNING: To reduce the risk of electric shock, this fan must be
installed with an isolating wall control/switch.
Insert the receiver into the ceiling mounting bracket with the
1
flat side of the receiver facing the ceiling. For best
performance, make sure the Black Antenna, on the end of
the receiver, remains extended and not tangled with any of
the electrical wires.
Motor to Receiver Electrical Connections: (Fig. 1)
2
Connect the black wire from the fan to the black wire
marked "TO MOTOR L" on the receiver. Connect the white
wire from the fan to the white wire marked "TO MOTOR N"
on the receiver. Connect the blue wire from the fan to the
blue wire marked "FOR LIGHT" on the receiver. Secure all
the wire connections with the plastic wire nuts provided.
Receiver to House Supply Wires Electrical Connections: (Fig. 2)
3
Connect the black (hot) wire from the ceiling to the black
wire marked "AC in L" from the receiver. Connect the white
(neutral) wire from the ceiling to the white wire marked "AC
in N" from the Receiver. Secure the wire connections with
the plastic wire nuts provided.
Your outlet box has a GROUND wire (Green or Bare
4
Copper) connect this wire to the Hanger Ball and Hanger
Bracket Ground wires. Secure wire connection with the
plastic wire nut provided.
Turn the wire nut connections upward, spreading them
5
apart so the green (ground) and white wires will be on one
side of the outlet box and the black and blue wires will be
on the other side. Carefully tuck the connections up into
the outlet box.
| hinkley.com
10
Outlet box
Black (hot)
Black ("AC IN L")
Black ("to motor L")
Blue (for light)
Blue (for light)
Black (motor)
White (neutral)
Green or bare copper
(ground)
White ("AC IN N")
Receiver
White ("to motor N")
Ground (green from
downrod)
Ground (green from
hanger bracket)
White (neutral)
Publicité
