U.N.O. Fitness CTX 1000 Mode D'emploi page 34

Assembly
Assembly:
For the assembly of this item we recommend to use the provided tools. Before starting to assemble
please check according to the part-list in this manual, if all parts are complete. Perhaps some
parts are already pre-assembled for your convenience.
For your safety in some cases lock nuts were used. Maybe it is a little difficult to screw them
tightly onto the respective screws, but they will not get loose easily (to ensure a safe connection).
If you should loose and fix those lock nuts several times, they will lose this lock mechanism.
In this case you should use new lock nuts of same size.
5R
A
(x4)
M8*1.25*75L
D22*D8.5*1.5T
D15.4*D8.2*2T
M8*1.25*15L
Stabilizers
Attach the front stabilizer (2) & rear stabilizer (19) to the main frame (1) with 2 bolts M8x75 (3), 2
curved washers (6), 2 spring washers (7) and 2 domed nuts (8).
The rear stabilizer (19) is equipped with caps with adjustable wheels (4) for compensation of
uneven floor if necessary. Adjust these end caps until the exercise bike is standing firmly on the
floor.
The front stabilizer (2) is equipped with transportation rolls, which allow you to move the item easily
from one place to another after assembling (please pay attention to protect your floor against
scratches and/or abrasion before any transport action).
Properly fix the stabilizers in order to avoid loosing them during exercise.
1
2
3
step-1
8
7
6
5L
34
3
19
4