Baldwin RESERVE Instructions D'installation

1. Adjust and install latch
Measure your door backset as shown.
If backset of door measured
2-3/4" (70mm), adjust latch shown
by grasping the spring pin and
moving it to the 2-3/4" slot.
Pin
LATCH ASSEMbLy AND INSTALLATION
Make sure the slant of latch bolt faces in the direction that the door closes.
For Square Corner and Round Corner
OR
Snap together front and back plate.
For Drive In Latch
Snap on collar.
Drive in with hammer.
2. Install chassis
A. Push and hold in latch bolt and install exterior chassis.
B. Insert interior chassis and install with screws.
exterior knob
chassis
A
OR
3. Install knob / lever
Place knob or lever onto interior chassis and turn set screw
clockwise to secure.
The set screws are pre-installed.
They do not need to be removed
prior to knob/lever installation.
Door Preparation
If your door requires drilling, use the supplied template below with the door preparation
instructions available at www.baldwinhardware.com
TEMPLATE
2-1/4"
(57 mm)
1-3/4"
(44 mm)
2"
2-3/8" 60mm
(51 mm)
1-3/8"
(35 mm)
2-1/2"
2-3/4" 70mm
(64 mm)
Install with 1/2" screws.
exterior lever
chassis
Please note: Product
illustrations may differ
from your product.
Installation is the same.
b
interior chassis
interior chassis
Fold
Doble
Plier
Centerline
Ligne médiane
Linea central
Entry Knob/Lever Installation Instructions
For lever type assembly, install cylinder and lever on exterior lever
chassis. Turn set screw clockwise to secure. Please note, the exterior
knob is pre-installed; no assembly is required.
exterior chassis
exterior
lever
cylinder
4. Install strike
THICK DOOR KIT INSTALLATION INSTRUCTIONS
(AvAILAbLE SEPARATELy)
Supports 2" (51 mm) up to 2-1/2" (64 mm) doors
After the completion of Step 1, install the longer turnbutton supplied in the
kit. Proceed to Step 2 and install with longer screws. During Step 4, install
strike supplied in the kit.
Knob Assembly
(After Rekeying)
exterior chassis
cylinder
exterior knob
1. Install collar, cylinder, and knob onto exterior chassis.
2. Rotate the collar until the projections on the chassis
align with the grooves on the collar.
3. Push the knob towards the collar and turn set screw
clockwise to secure.
WARNING: This Manufacturer advises that no lock can provide complete security by itself.
This lock may be defeated by forcible or technical means, or evaded by entry elsewhere
on the property. No lock can substitute for caution, awareness of your environment, and
common sense. Builder's hardware is available in multiple performance grades to suit the
application. In order to enhance security and reduce risk, you should consult a qualified
locksmith or other security professional.
The drilling template must be printed to scale to
ensure correct hole placement. To confirm correct
print scale, the square below must measure exactly
Measure
after printing.
Copyright © 2011 Baldwin Hardware Corporation
Fits 1-3/8" (35 mm) up to 2" (51 mm) doors
(Thick door service kits for
2" (51 mm) up to 2-1/2" (64 mm) doors
available through customer service)
Adjust tang as needed.
Remove existing turnbutton.
Install longer turnbutton.
collar
1" by 1" (25mm x 25mm).
1"
25mm
1"
1"
25mm
25mm
47042 / 01