Iomega ditto Manuel D'installation page 9

9 Thread the tape cable through the bay opening where
the tape drive will be installed and go directly to step
16 (skipping steps 10 - 15).
10 If you do not have a Ditto Dash DX accelerator card,
locate your floppy drive cable and find where it
connects to your computer. (You can trace the cable
from the rear of your floppy drive to its connection on
the computer.)
11 Now look at the cable and find the striped edge,
making a note of how the stripe on the cable is
oriented to the connector. (Is it on the left or right
side, top or bottom?)
12 After identifying the striped edge of the floppy drive
cable, unplug it from the computer.
Floppy Drive
All manuals and user guides at all-guides.com
Co
Floppy Drive Cable
9