Bartec CAK-E10-A Consignes D'installation page 5

Kit contents
The following table lists the kit contents for the End seal for self-regulating trace heaters kit:
End seal for self-regulating trace heaters
Installation
Required tools
The following tools are required for installation the End seal for self-
regulating trace heaters:
 Wire cutters
 Utility knife
 Tape measure
21-59CZ-7D0003
1
Notice Technical data subject to change without notice.
No claims for damage arising from alternations, errors or misprints shall be allowed.
10 x
End seal
Cautions and warnings
WARNING
Risk of fire or electrical shock. De-energize all power circuits before
installation or servicing. Always use ground fault equipment within
the heat tracing system.
 Double-check that all power circuits are de-energized before you
begin your work.
 Make sure that you do not exceed the maximum heating
circuit length for the trace heater type you use. Refer to
the design guide of the heating system.
Preparation of the trace heater
WARNING
Risk of short cuts and/or material damage. Keep the trace heater
ends dry before and during installation. Observe the design guide of
the trace heating system.
 Cut off the trace heater ensuring a straight cut.
2 x
Silicone adhesive
2
3
Page 3 / 9