Publicité
Maintenance
Precautions & General
Maintenance (See 7)
•
Place the set on a hard and flat surface so
that the system does not tilt.
•
Do not expose the set, batteries, CDs to
humidity, rain, sand or excessive heat caused
by heating equipment or direct sunlight.
•
Do not cover the set. Adequate ventilation
with a minimum gap of 6 inches between the
ventilation holes and surrounding surfaces is
necessary to prevent heat build-up.
•
The mechanical parts of the set contain
self-lubricating bearings and must not be oiled
or lubricated.
•
To clean the set, use a dry cloth. Do not use
any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may
harm the housing.
Tape deck maintenance (See 7)
To ensure quality recording and playback of
the tape deck, clean parts A, B and C as
shown, once a month. Use a cotton bud
slightly moistened with alcohol or a special
head cleaning fluid to clean the deck.
1 Open the cassette holder by pressing 9/.
2 Press 2 and clean the roller C.
3 Press ; and clean the heads A, and the
capstan B.
4 After cleaning, press 9.
Cleaning of the heads can also be done by
playing a cleaning cassette through once.
CD player and CD handling (See 7)
•
If the CD player cannot read CDs correctly,
use a cleaning CD to clean the lens before
taking the set to repair.
•
The lens of the CD player should never be
touched!
•
Sudden changes in the surrounding
temperature can cause condensation on the
lens of your CD player. Playing a CD is then
not possible. Do not attempt to clean the
lens but leave the set in a warm environment
until the moisture evaporates.
•
Always close the CD-tape door to avoid dust
on the lens.
•
To clean the CD, wipe in a straight line from
the center towards the edge using a soft,
lint-free cloth. Do not use cleaning agents as
they may damage the disc.
•
Never write on a CD or attach any stickers
to it.
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock. Under no cir-
cumstances should you try to repair the set yourself, as this will invali-
date the guarantee.
Problem
- Possible cause
• Remedy
No sound /power
- Volume not adjusted
• Adjust the VOLUME
- Power cord not securely connected
• Connect the AC power cord properly
- Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
Display does not function properly/ No
reaction to operation of any of the con-
trols
- Electrostatic discharge
• Switch off and unplug the set. Reconnect after a
few seconds
The CD skips tracks
- CD damaged or dirty
• Replace or clean CD
- Program is active
• Quit program mode
Environmental information
All unnecessary packaging material has been omitted.The packaging can be easily separated
into three materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled by a
specialized company. Please observe the local regulations regarding the
disposal of packaging, dead batteries and old equipment.
-- indication
- No CD inserted
• Insert a CD
- CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
- Laser lens steamed up
• Wait until lens has cleared
- CD-R is blank or not finalized/ CD-RW inserted
• Use a finalized CD-R or suitable CD Audio disc
only
Poor cassette sound quality
- Dust and dirt on the heads, etc.
• Clean deck parts, see Maintenance
- Use of incompatible cassette types (METAL or
CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
- Cassette tab(s) may be broken
• Apply adhesive tape over the missing tab space
Publicité
