Worx JAWHORSE WX060.1 Mode D'emploi page 8

SYMBOLS
Read the manual
Warning
Wear eye protection
Wear ear protection
Wear dust mask
Pinch points
Keep stander-by away
8
Wear gloves
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The JAWHORSE is a versatile workstation for
®
holding, clamping, supporting.
1. SET-UP INSTRUCTIONS (See Fig. A-E)
1) Put the JAWHORSE
ground, loosen the rear leg locking knob (9)
and slide the rear leg from its storage position.
Pivot the leg to position and slide it all the way
upward, then lift and slide it fully into its housing
at the rear. Tighten the knob. (See Fig. A-C)
2) Raise the foot pedal (6) until it "clicks" into
position. (See Fig.D-E)
Portable versatile workstation
All manuals and user guides at all-guides.com
upside down on the
®
3) Rotate the front legs (5) all the way forward
until they "click" into position. The front leg
locking latch (3) will be open automatically.
(See Fig. E)
4) Turn the JAWHORSE
®
that all legs are locked firmly in position.
2. FOLDING INSTRUCTIONS (See Fig. F-I)
Folding is the reverse procedure of above.
1) Set the Lock/Release switch in the "Release"
position.
2) Slide the front leg locking latch and fold the
front legs into position. (See Fig. F)
3) Draw the foot pedal locking latch and place
the foot pedal in folding position. (See Fig. G)
4) Loosen the rear locking knob. Slide the
rear leg from housing and back into storage
position. Make sure the rear leg is engaged
fully into storage position and the rear leg
locking knob is tightened firmly. (See Fig. H)
5) You can carry the rear leg as a carry handle
when the JAWHORSE
®
position. (See Fig. I)
3. CLAMPING (See Fig. J-L)
1) Place the workpiece against the fixed jaw
and slide the moving jaw forward until it
touches the workpiece. (See Fig. J)
The foot pedal can be pressed repeatedly to
make the jaw move forward.
2) Set the Lock/Release switch to the "Lock"
position. (See Fig. K)
3) Apply downward pressure on the foot pedal
until enough clamping force is applied. (See Fig. L)
WARNING: Do not stand or jump
on the foot pedal, as you can cause
injury or damage the unit.
4. RELEASING (See Fig. L-M)
1) Set the Lock/Release switch to the "Release"
position.
2) Push on the foot pedal, allow it to return up
and release the workpiece. (See Fig. L)
If you have clamped the object very tightly,
you must exert similar pressure on the foot
pedal before it will release.
WARNING: Ensure you are
supporting the workpiece to avoid
its falling when the jaw is released.
3) Slide the moving jaw back and remove your
workpiece. (See Fig. M)
upright and recheck
is fully folded in its
EN