Jandy JHCBUB Manuel Du Propriétaire page 11

All manuals and user guides at all-guides.com
TruFit Bubbler | Owner's Manual
2.4 LED Light Installation
The Jandy TruFit
be fitted with a Jandy
tests have been completed and the Small Construction Cover has been
removed, you are ready to install the Jandy HydroCool Nicheless Light into
the Bubbler Housing.
1. Feed the power cable through the housing and conduit to the power
source. Allow 18"-24" slack for service loop.
2. Place the Light into the Bubbler and tighten into the threaded housing.
3. See the Jandy HydroCool Nicheless light Owner's Manual for light
installation instructions.
Section 3.
The water level should be lowered to approximately 12 inches below the
pool lights. Make certain that the water is drained out of the housing.
Consult a Local Swimming Pool Professional for proper winterization.
Minimum safeguard requires dropping the water level 2"-4" below the
light. At NO TIME should there be water removed from the pool without
checking ground water tables.
Section 4.
Use the troubleshooting information in the following table for suggestions.
Symptom
All lights fail to illuminate
One or more lights are dim,
blinking or not working
Colored lights out of synch
Bubbler with Pressure Check Technology is designed to
TM
HydroCool Nicheless Pool Light. Once the pressure
®
Winterizing
Troubleshooting
Problem
Lights are not
receiving power
Poor connection
or improper wire
gauge
Improper voltage
supply or poor
connection to the
light
ENGLISH
Corrective Action
Check 120VAC power supply into
transformer. Check for 12VAC output at
transformer. If 120 volts was used in the
installation, damage may result and will
not be covered under warranty.
Separate each light and independently
wire 12V to the single light only. Repeat
this process on each light. If junction box
is being used, check for proper connec-
tion of light cord. Verify that the correct
wire gauge is being used between the
transformer and junction box.
Verify that proper wire connections are
being achieved for the lights that are out
of synch. Reset all the lights to white by
turning lights OFF for five (5) seconds,
then turning ON.
Page 11