Kalorik WCL 47492 S Mode D'emploi page 10

All manuals and user guides at all-guides.com
TEMPERATURE SETTINGS AND DISPLAY
The appliance is for wine storage at temperatures ranging from 37.4°F to 64°F
(3°C to 18°C). The digital display shows the current temperature of the cooler's
interior. The digital display will activate 20 seconds after the last time a button has
been touched.
The temperature is factory preset when the cooler is off the assembly line. To
change any presets, do as follow:
1) When the power source is connected, the cooling system will begin to work.
2) Once you finish the temperature setting, after 12 seconds it will automatically
lock into status. To unlock the control panel, press the
seconds, it will beep to confirm command.
3) Press the
button also displays the temperature settings in blue on the control panel.
When the control panel is unlocked, push the
temperature display will be off; you must push the button again to turn the
LED temperature display back on.
4) The temperature is set on certain temperature level, which means that when
the inner temperature reaches the set point, the appliance will stop cooling,
so that the temperature in the cooler rises gradually.
5) The temperature is displayed in Fahrenheit (ºF) ranging between 37.4º - 64ºF.
To change temperature display from Fahrenheit to Celsius, press the
button for two (2) seconds. The number on the control panel will flash and
change to Celsius.
6) To set a desired temperature, press
press button for lower temperature setting. The temperature will
increase/decrease by 1 degree with each press of the button.
7) When the inside temperature rises above the set point, cooling will resume
until reaching this set point once again, and the center enters its cooling
cycles.
www.KALORIK.com
button to turn on or off the light inside the appliance. This
once and the LED
button for higher temperature or
10
for two (2)
WCL 47492 S - 200605