Aspes SA613 Manuel D'instructions page 7

INSTALLATION
This tumble dryer must be installed in a well aired room in order to make easier the exausting of the wet air produced by
the appliance during the drying cycle.
This aering can be carried out both opening a window or by means of a fan.
Depending on which model you have, the drier can be supplied with one or three
outlets (one on the back side and one on both lateral sides).
It is also possible to evacuate the air out of the room by means of a flexible venting hose supplied with the appliance.
The drier can be installed on the floor and leveled by means of four adjustable feet. You
can also stack the dryer on the top of a front loading washing machine (see WASHING
COLUMN).
CONNECTION TO THE OUTSIDE
If you want to evacuate the humid air out of
the room you have to fit a flexible venting
hose on the back side of the dryer.
The drawing shows the 2 mt. long flexible
hose with the fastening bracket and the
adapter available at request.
WASHING COLUMN
If you need room, your tumble dryer can be easily stacked on the top of a front loading
washing machine. For this purpose you need a stacking kit available as optional. After
you have put the dryer on the top of your washing machine, don't forget to adjust the 4
feet. The drawing beside shows how to set the stacking kit.
SOME HINTS
To achieve the best drying results be sure that the tumble
dryer works in a room where the temperature is not lower
than 10° C.
Before carrying out the first drying cycle clean the inside
of the drum by means of a wet cloth so as to remove the
thin layer of dust that can form during the carriage and
storage.
ELECTRICITY CONNECTION
Before connecting the tumble dryer be sure that:
1. the value of the voltage is equal to that one written on
the data-plate placed on the rear side of the dryer;
2. the domestic wiring system (including wall-socket, fuses,
interior wiring, electricity meters) and the plug are
adequate and suitable to carry the maximum load
demanded: the values of the rated input and of the
rated current are written on the data-plate;
3. the wall-socket and the plug fit without using any adaptor
or extention. If necessary, change the wall-socket with
a suitable-one.
4. The appliance must be properly earthed.This outlet must
be easily accessible after the installation of the dryer.
All manuals and user guides at all-guides.com
GB
WARNING
If the supply card is damaged, it should be replacad
by a special cable available at the manufacturers or
at the technical service.
The manufacturer cannot be held responsible for
personal injury or damage caused if the elementary
safety practices and the advices herewith mentioned
are ignored.
8
The tumble dryer must not be ever connected to a
chimney.
The room in which the tumble dryer is installed must be
free from dust and fluff.